Table of Contents
Advertisement
3.10. MEM Command
The calibrator offers several programming and special functions that can be
often used. In this case, storing these configurations in the calibrator saves time. One
can have up to eight sequences stored in memory.
After making a specific operation in the calibrator through the keyboard, return
to the menu CONF. Select MEM and press ENTER. The display will show:
Select WRITE and press ENTER. The display will show:
The numbers shown above represent eight memory positions. Select any of
them and press ENTER. The calibrator preset configuration is stored in the chosen
memory. In order to call it back, even though the calibrator has been turned off and
on, select RECALL (ENTER) and the memory number that stored the previous
configuration. Press ENTER.
Any new configuration can be written over an already used memory location.
When you want to clear all eight memory locations, select CLEAR ALL and
press ENTER.
WRITE
CLEAR ALL
1
2
5
6
RECALL
3
4
7
8
Page 47
Hide quick links:
Advertisement
Table of Contents
