Table of Contents
Advertisement
SCALE and CONV functions may be disabled by selecting the NO option and pressing ENTER, as shown
below:
47
2.10. MEM Command
The calibrator accepts a great amount of programmations and special functions that can be often used. In
this case, storage of these configurations in the calibrator saves time. One can have up to eight sequences stored in
memory.
After making a specific operation in the calibrator through the keyboard, return to the menu that shows MEM.
Then select MEM and press ENTER. The display shows:
Select WRITE and press ENTER. The display will show:
The numbers shown above represent eight locations of memory. Select any of them and press ENTER. The
current configuration is then stored in the chosen memory location. In order to recall it, even though the calibrator is
turned off and on, select RECALL (ENTER) and the memory number that stored the previous configuration. Then
press ENTER.
Any new configuration can be written over an already used memory location.
SCALE
CONV
WRITE
CLEAR ALL
1
2
5
6
NO
RECALL
3
4
7
8
Advertisement
Table of Contents
