Remote Access - Vnc; Command List Scpi - Presys TA-1200PLAB Technical Manual

PRESYS
 Instruments
To verify the IP address press the button indicated below.
In the Web Server, you can monitor the calibrator screen, change the setpoint and
see the auxiliary input readings.

3.3.2 - Remote Access - VNC

Virtual Network Computing (or VNC only) is a graphical desktop sharing system
that uses the Remote Frame Buffer protocol (RFB) to remotely control another computer
or device. When activating this option, the calibrator screen can be accessed directly on
the computer.
To access via VNC, it is necessary to download and install a VNC viewer program,
some of which are available for free on the internet. Connect the calibrator to the network
via Ethernet or Wifi cable. Set the IP address indicated on the network icon in the VNC
viewer (Figure 24) and connect. When prompted, use the password "adm". This password
can be changed later on the NETWORK → FILE SHARING tab of the calibrator.

3.3.3 - Command List SCPI

To control the calibrator using the SCPI commands, connect a serial cable to the
USB HOST port on the Calibrator TA (see Figure 5 - Parts identification). Connect the
cable to the computer's serial port. In the Settings → Services → Serial Comm menu,
activate the RUN key to
Communication Parameters:
Parity: none
Data bits: 8
Baud rate: configurable in the menu Configuration → Services → Serial Comm
Stop Bits: configurable in the Configuration → Services → Serial Comm menu
Page 18
Fig. 17 - TA Calibrator Web Server
.
TA-1200PLAB