Table of Contents
Advertisement
lower line of the display (chosen in OUT). Note that the units are distributed in
several lines. In order to move the cursor through the units use the keys:
and
. After selecting the unit, press ENTER.
The available units are written below between parentheses beside the
corresponding mnemonics presented in the calibrator display:
PSI
INW
MMW
MMH
KPA
PARAM - configures the calibration parameters of the pressure sensors
provided by the manufacturer.
DT - updates the date and time for the calibrator. Thus, when it performs a
calibration within the communication option, calibration data is recorded together with
their date and time of occurrence.
Whenever the calibrator is turned off, the date and time are not updated any
longer. Thus, if you want them to be recorded with the calibration, you should update
them. Use the vertical arrow keys
the horizontal arrow keys
the last selection
(psi)
ATM (atm)
(inH
O)
MW
2
(mmH
O)
INH
2
(mmHg)
BAR (bar)
(kPa)
TOR
and
and
to go to another value. The ENTER key confirms
KG
(mH
O)
CMW (cmH
2
(inHg)
CMH (cmHg)
MBA (mbar)
(torr)
PA
to change the value which is blinking and
Page 19
,
2
(kgf/cm
)
O)
2
(Pa)
,
Hide quick links:
Advertisement
Table of Contents
