Table of Contents
Advertisement
is pressed, an ascending cycle starts, and by pressing , a descending cycle begins, only
once. Pressing
3.9. Special Functions
Selecting FN the display shows:
Through these options, you may select special functions related to the INPUT
or the OUTPUT.
INPUT has the SCALE, CAL and NO options.
The input type must be previously configured; otherwise the SELECT INPUT
FIRST message will be displayed. In this case, press C/CE to go back to the main
menu and select the input type.
3.9.1. SCALE Function (IN)
It establishes a linear relationship between the calibrator input signal and what
is shown on the display, according to the graphic below.
The scaled display indication (#) may represent any engineering unit, such as
3
m/s, m
/s, % etc.
and , the cycles are repeated continuously.
INPUT
OUTPUT
Page 39
Hide quick links:
Advertisement
Table of Contents
