Table of Contents
Advertisement
18.7.99
Notes on operation
Installing the base station
Installation site/installation area
Temperature/ambient conditions
kap03.fm5
Gigaset 2010, LAM/engl.: A30852-X1100-B313-1-7619
A 220/230V (AC adapter C39280-Z4-C59) or 110/120V
(AC adapter C39280-Z4-C69) power socket must be lo-
cated at the installation site.
In order to avoid interference, the base station should
not be in the direct vicinity of other electronic equip-
ment such as Hi-fi, office or microwave equipment.
Place the base station on a level, non-slip surface.
The device feet do not normally leave any unsightly
marks. However, due to the variety of varnishes and
polish used on furniture, the possibility of marks can-
not be entirely ruled out.
Radio transmission between the base station and
handsets complies with the DECT standard. Gigaset
2010 Tango thus observes all relevant regulations.
However, if there is interference to the picture or
sound of your satellite equipment, consult your spe-
cialist satellite dealer.
Depending on ambient conditions, the maximum ra-
dio range between the base station and the handset
is approx. 300 m outdoors, and approx. 50 m indoors.
If the range warning is activated for the handset
(
page 36), a signal will sound when you move out-
side the radio range.
The base station is designed for operation in protect-
ed areas with a temperature range from +5 °C to
+45° C.
The base station should not be installed in damp are-
as (such as bathrooms or laundry rooms), or close to
heat sources, or in direct sunlight.
Notes on operation
5
Advertisement
Table of Contents
