Parameters Of The Digital Output Modules - Siemens Simatic M7-400 Reference Manual

A.3

Parameters of the Digital Output Modules

Parameters
The table below contains all the parameters you can set for digital output modules.
The comparison shows:
• Which parameters you can change with STEP 7 and
• Which parameters you can change with SFC 55 "WR_PARM"
The parameters set with STEP 7 can also be transferred to the module with SFCs
56 and 57 (refer to the STEP 7 manuals).
Table A-3
Destination CPU for Interrupts
Diagnostics
Diagnostic interrupt enable
Reaction to CPU STOP
Enable substitute value "1"
Note
If you want to enable the diagnostic interrupt in the user program in data record 1,
you must enable the diagnosis in data record 0 beforehand using STEP 7.
S7-400, M7-400 Programmable Controllers Module Specifications
A5E00069467-07
Parameters of the Digital Output Modules
Parameter
Parameter Sets for Signal Modules
Data Record
Parameters Can Be Assigned
No.
... SFC 55
No
0 0
No
Yes
Yes
1
Yes
with ...
... STEP 7
Yes
Yes
Yes
Yes
Yes
A-7