Siemens Simatic M7-400 Reference Manual page 572

Parameter Sets for Signal Modules
A.4 Parameters of the Analog Input Modules
Parameters
The table below contains all the parameters you can set for analog input modules.
You will see which parameters you can modify from the list:
• in STEP 7
• with SFC 55 "WR_PARM"
The parameters set with STEP 7 can also be transferred to the module with SFCs
56 and 57 (refer to the STEP 7 manuals).
Table A-4 Parameters of the Analog Input Modules
Destination CPU for Interrupts
Measuring Type
Measuring Range
Diagnostics
Temperature Unit
Temperature Coefficient
Interference Suppression
Smoothing
Reference Junction
End-of-scan-cycle interrupt
Diagnostic interrupt enable
Hardware interrupt enable
Reference Temperature
High Limit
Low Limit
Note
If you want to enable the diagnostic interrupt in the user program in data record 1,
you must enable the diagnosis in data record 0 beforehand using STEP 7.
A-10
Parameter
S7-400, M7-400 Programmable Controllers Module Specifications
Data Record Parameters Can Be Assigned
No.
... SFC 55
No
No
No
No
No
0 0
No
No
No
No
No
Yes
1 1
Yes
1 Yes
1 Yes
1 Yes
with ...
... STEP 7
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
A5E00069467-07