Canon Inner Finisher-A1 Service Manual page 43

4
Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the STP Move Motor/Gripper Unit Move Motor
6) Remove the additional tray harness (only when the additional tray is installed).
7) Remove the tray.
9) Remove three screws and then the grate-shaped guide (lower).
x3
4 Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the STP Move Motor/Gripper Unit Move Motor
8) Move the gripper unit in the direction of the arrow.
F-4-63 F-4-63
10) Remove two wire saddles.
11) Disconnect the relay connector and one screw.
x2
F-4-65 F-4-65
x1 x1
4-23
F-4-64 F-4-64
F-4-66 F-4-66
4-23