Canon Inner Finisher-A1 Service Manual page 40

4
Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the Shift Motor
3) Disconnect one flexible cable and eight connectors.
4) Remove one wire saddle.
5) Remove two screws, and then pull out the finisher controller PCB along with the mount.
x9
x2
x1
7) Disconnect eight connectors.
x8
4 Parts Replacement and Cleaning Procedure > Removing the Motors > Removing the Shift Motor
6) Remove four wire saddles and the harness from the harness guide, and then pull out the finisher
controller PCB along with the mount.
F-4-52 F-4-52
8) Disconnect the relay connector of the shift motor cale.
9) Disconnect the relay connector.
10) Remove one wire saddle and then the harness leading to the upper guide from the harness guide.
x1
F-4-54 F-4-54
x4
x1
4-20
F-4-53 F-4-53
F-4-55 F-4-55
4-20