Usb 3.1 Type-C Host Port; Pfi 0; Power Connector - National Instruments NI cRIO-905x Series User Manual

USB 3.1 Type-C Host Port

The USB host port on the cRIO-905x support common USB mass-storage devices such as
USB Flash drives, USB-to-IDE adapters, keyboards, mice, and USB cameras.
The following NI USB Type-C adapters are available for the cRIO-905x.
USB Cable with Retention, Type-C Male to Type-A Female, USB
3.1, 3A
The following NI cables with retention are available for use with the cRIO-905x.
USB Cable with Retention, Type-C Male to Type-C Male, USB 3.1,
3A

PFI 0

The Programmable Function Interface (PFI) terminal is a SMB connector. You can configure
the PFI terminal as a timing input or timing output signal for AI, AO, DI, DO, or counter/timer
functions.
Note
The PFI 0 terminal can only be used while the module is in the Real Time
programmatic mode. For more information about programming modes, refer to
Choosing Your Programming Mode.

Power Connector

The cRIO-905x has a power connector to which you can connect a power supply.
Pinout
Table 2. NI USB Type-C Adapters for cRIO-905x
Cable
Table 3. NI USB Cables with Retention
Cable
Table 4. Power Connector Pinout
V
C
Pin
V Power input
C Common
NI cRIO-905x User Manual | © National Instruments | 7
Length Part Number
0.5 m 143555-0R5
Length Part Number
0.3 m 143556-0R3
1 m 143556-01
2 m 143556-02
Description