National Instruments NI cRIO-905x Series User Manual page 29

Figure 23. Mounting the 8-slot cRIO-905x on a Panel
1
2
1. Align the cRIO-905x and the panel mounting plate.
2. Fasten the panel mounting plate to the cRIO-905x using the screwdriver and M4 x 10
screws.
Note
because they are the correct depth and thread for the panel mounting plate.
Tighten the screws to a torque of 1.3 N · m (11.5 lb · in.).
3. Fasten the panel mounting plate to the surface using the screwdriver and screws that are
appropriate for the surface. The maximum screw size is M5 or number 10.
You must use the screws provided with the NI panel mounting kit
NI cRIO-905x User Manual | © National Instruments | 29