Connecting The Device To The Host Computer Using Usb - National Instruments NI cRIO-905x Series User Manual

Type-C Device Port with Console Out. NI recommends using the USB 2.0 Type-C
Device Port with Console Out for configuration, debugging, and maintenance.
Connecting the cRIO-905x to the Host Computer Using
USB
Complete the following steps to connect the cRIO-905x to the host computer using the USB
2.0 Type-C Device Port with Console Out.
1. Power on the host computer.
2. Connect the cRIO-905x to the host computer using the USB Type C to Type A cable
(included in kit), inserting the USB Type-C connector into the USB 2.0 Type-C Device
Port with Console Out.
3. Connect the other end of the USB cable (Type-A) to the host computer.
Note
device driver software does not detect the cRIO-905x, verify that you installed
the appropriate NI software in the correct order on the host computer as
described in Installing Software on the Host Computer in the NI cRIO-905x
Getting Started Guide.
4. Select Configure and install software to this device.
The device driver software automatically detects the cRIO-905x. If the
NI cRIO-905x User Manual | © National Instruments | 3