Table of Contents
Advertisement
Menu List
Note
The following conventions are used in the menu list table.
Settings column values (e.g. ON, OFF, 0): Default settings are underlined
Execute via ENTER: Press the CONTROL knob or move the CANCEL/ENTER lever to the ENTER position to execute.
SYSTEM CONFIG menu
SYSTEM CONFIG
Page name
Item
Page No.
<CAMERA I/F>
CABLE TYPE
S01
FIBER TRANSMIT
RATE
OPTICAL SIGNAL
BARS
TEST
START UP VIDEO
SIGNAL
<VIDEO I/O>
SDI-I/O 1
S02
SDI-I/O 2
SDI-I/O 3
SDI-I/O 4
Set value
FIBER CAMERA CABLE
HIGH, HD
ON, OFF
OFF, ON
OFF, TEST1, TEST2
BARS, GRAY
I/O
IN, OUT
SIGNAL
When OUT is selected in I/O:
SDI-OUT
When IN is selected in I/O:
SDI-RET
I/O
IN, OUT
SIGNAL
When OUT is selected in I/O:
SDI-OUT
When IN is selected in I/O:
SDI-RET
I/O
IN, OUT
SIGNAL
When OUT is selected in I/O:
SDI-OUT, HD TRUNK
When IN is selected in I/O:
SDI-RET
I/O
IN, OUT
SIGNAL
When OUT is selected in I/O:
SDI-OUT
When IN is selected in I/O:
SDI-RET, HD PROMPTER
Description
Specifies the cable type used for connecting the
camera.
Sets the transfer rate when an optical fiber cable is
connected.
HIGH: When the HDC2000 series is connected
HD: When the HSC300RF/100RF is connected
Turns the optical signal output from the CCU to the
camera ON/OFF.
(Displayed only when connected using optical fiber
composite cable.)
Turns color bars ON/OFF.
Turns TEST SAW ON/OFF.
Selects the signal to output until the unit connects
with the camera after power-on.
Sets SDI-I/O 1.
Selects input or output.
Sets the signal purpose.
Sets SDI-I/O 2.
Selects input or output.
Sets the signal purpose.
Sets SDI-I/O 3.
Selects input or output.
Sets the signal purpose.
Sets SDI-I/O 4.
Sets the signal purpose.
16
Hide quick links:
Advertisement
Table of Contents
