Appendix; Precautions; Error Messages - Sony HDCU3100 Operating Instructions Manual

Appendix

Precautions

If the unit is suddenly taken from a cold to a warm location, or
if ambient temperature suddenly rises, moisture may form on
the outer surface of the unit and/or inside of the unit. This is
known as condensation. If condensation occurs, turn off the
unit and wait until the condensation clears before operating
the unit. Operating the unit while condensation is present may
damage the unit.
The fan and battery are consumable parts that will need
periodic replacement.
When operating at room temperature, a normal replacement
cycle will be about 5 years. However, this replacement cycle
represents only a general guideline and does not imply that
the life expectancy of these parts is guaranteed. For details on
parts replacement, contact your Sony representative.
The life expectancy of the electrolytic capacitor is about
5 years under normal operating temperatures and normal
usage (8 hours per day; 25 days per month).
If usage exceeds the above normal usage frequency, the life
expectancy may be reduced correspondingly.
Operating environment
• Avoid high-temperature rooms and near sources of heat.
• Do not place in locations with strong electric or magnetic
field.
• Dry location with good ventilation.
• Avoid locations exposed to sunlight or strong lighting.
Avoid violent impacts
Dropping the unit, or otherwise imparting a violent shock to it,
is likely to cause it to malfunction.
Do not cover with cloth
While the unit is in operation, do not cover it with a cloth or
other material. This can cause the temperature to rise, leading
to a malfunction.
After use
Set the POWER switch to the OFF position.
Care
If the body or panels of the unit become dirty, wipe them with
a dry cloth. For severe dirt, use a soft cloth steeped in a small
amount of neutral detergent, then wipe dry. Do not use volatile
solvents such as alcohol or thinners, as these may damage
the finish.
To prevent electromagnetic interference from
portable communications devices
The use of portable telephones and other communications
devices near this unit can result in malfunctions and
interference with audio and video signals.
It is recommended that the portable communications devices
near this unit be powered off.

Error Messages

When an error is detected in this unit or the camera, the
ALARM indicator turns on and an error message is displayed
on this unit.
Error Messages
CCU:XXX POWER ERROR
CCU:XXX PLD ERROR
CCU:XXX TEMP WARNING
CCU:OPTICAL CONDITION OK Light sensor level on CCU side
CCU:OPTICAL CONDITION
WARNING
CCU:OPTICAL CONDITION
CARE
CCU:OPTICAL CONDITION
ERROR
CCU:PS FAN STOP
CCU:PS CABLE SHORT
CCU:PS CABLE OPEN
CCU:PS RCP POWER SUPPLY
ERROR
CCU:PS TEMP WARNING
CCU:PS POWER ERROR
CCU:PS POWER WARNING
CCU:FRONT FAN1 STOP
CCU:PS REAR FAN STOP
CCU:GENLOCK ERROR
CCU:FORCE LEGACY
CCU:10FIELD-ID ERROR
CCU:SET DATE&TIME
31
Description
Board power supply error (XXX
is the board name)
PLD error (XXX is the board
name)
Board temperature error (XXX is
the board name)
dropped
Power supply block FAN error
CAMERA connector optical fiber
cable short circuit error
CAMERA connector optical fiber
cable open circuit error
Remote control panel
(connected to REMOTE
connector) power supply error
Power supply unit temperature
error
Power supply unit input/output
error
Front board FAN1 stop
Power supply block rear FAN
error
External reference sync error
FORCE LEGACY is set for CNS
MODE
10Field ID is not detected even
though the 10F BB setting is On
Invalid date