Rear Panel - Sony HDCU3100 Operating Instructions Manual

k INTERCOM audio input/output and control block
MIC/PGM (microphone/program) switch
INTERCOM (intercom select) switch
INTERCOM (intercom adjustment) knob
• INTERCOM (intercom adjustment) knob
Adjusts the headset audio level.
• MIC/PGM (microphone/program) switch
ON: Turns the headset microphone on.
OFF: Turns the headset microphone off.
PGM: Selects program audio output.
• INTERCOM (intercom select) switch
Selects the intercom signal input/output connection source for
the INTERCOM connector on the front panel.
PROD: Connects the producer line.
PRIV: Blocks the connection to the producer line or engineer
line, allowing private intercom talk between the CCU and
the camera.
ENG: Connects the engineer line.
• PRIV (private) indicator
Lights when the intercom is in private mode.
• INTERCOM connector (XLR 5-pin)
Connects the intercom headset.
l Call button
When pressed, this outputs a call signal to the camera or
external control device (the RCP-1000 series, etc.) that are
connected to this unit. Use this when you want to call and
speak with the camera operator or external control device
operator via intercom. This button lights in red when it is
pressed or the call button of other equipment is pressed.

Rear Panel

1
qf
a AUDIO OUT CH1, CH2 (audio output 1, 2) connectors
(XLR 3-pin)
Used to output the audio signal to the AUDIO IN connectors of
the video camera.
PRIV indicator
INTERCOM connector
2 3 4 5 6
qg qh
m USB port
Used to connect to a USB device.
n Assignable button
You can set a function for this button via the CCU menu.
o Filter cover
Press the filter cover in the direction of the arrow while pulling
it to remove it.
The filter (black sponge) is placed under the cover. If the filter
becomes dirty, you can remove it and clean it with cold or
warm water. When using a detergent, use a neutral solution.
Be sure to dry the filter thoroughly before replacing it on the
unit.
p POWER switch
Turns the entire camera system on and off, including the unit,
the camera, and the RCP-1000 series Remote Control Panel
connected to the REMOTE connector of this unit. Switch to ?
to turn the power on, and switch to a to turn the power off.
q Status display indicators
REF IN (green): Indicates presence of reference input signal.
UNLOCK (red): The input reference is not locked.
RCP/MSU: Displays the status when there is a remote control
panel connected.
On: Indicates that external control equipment (MSU-1000/
1500 Master Setup Unit, RCP-1000 series Remote
Control Panel, or other equipment) is connected.
Off: Indicates that the external control equipment is not
connected.
For details, see "NETWORK menu" (page 29).
NETWORK: Reserved for future use.
ALARM: Lights when various errors occur.
FAN STOP: Lights when the fan is stopped.
r Menu lock switch
Locks out operation of the front panel menu operation area.
7 8 9 0 qa
qj
b Rear indicator
Displays calls and statuses.
c Expansion board mounting port
Reserved for future use.
6
qs qd