Sony HDCU3100 Operating Instructions Manual page 17

SYSTEM CONFIG
Page name Item
Page No.
<REAR I/F> CHARACTER/AES-
EBU
S03
PROMPTER2/VBS-
RET
MIC/WF REMOTE
REAR PREVIEW
<GENLOCK> REFERENCE
S04
LOCK STATUS
GENLOCK MODE
H-PHASE STEP
H-PHASE COARSE
V-PHASE
SYNC OUT SELECT
Set value
CHARACTER, AES-EBU
ENABLE, DISABLE
MIC REMOTE, WF REMOTE
MOMENTARY, TOGGLE
NOT DETECTED, EXT IN, 1080/
59.94I, 1080/23.98PsF, 720/
59.94P, 1080/50I, 1080/24PsF,
720/50P
When HD or SD is selected in
GENLOCK MODE:
LOCKED, NOT LOCKED
HD, SD
10F BB OFF, ON
When HD is selected in GENLOCK
MODE:
–3.01 to 3.45 µsec 0.00
When SD is selected in GENLOCK
MODE:
–8.29 to 9.48 µsec 0.00
–99 to 99, 0
0 to 7
SD SYNC, HD SYNC
Description
Sets the function to assign to the CHARACTER/
AES-EBU connector.
CHARACTER: Set to VBS output on which
character superposition is performed.
AES-EBU: Set to AES-EBU output.
Sets the function to assign to the PROMPTER2/
VBS-RET connector.
ENABLE: Set to both signal input for the second
tele-prompter and VBS return signal input.
DISABLE: The PROMPTER1 input signal is output
as is (loop-through output).
If loop-through output is not used, terminate the
connector at 75 ohms.
Switches the function of pins 36 to 43 when a D-sub
50-pin board is mounted as the INTERCOM/TALLY/
IO PORT connector.
Sets the operation mode of REAR PREVIEW
connector output.
Signal input of the Reference connector. (Display
only)
Lock status of the external reference signal. (Display
only)
Selects the lock mode of the external reference
signal.
Sets whether to use the 10Field ID added to the
external reference signal.
This can be selected when GENLOCK MODE is SD
and <MULTI FORMAT> page t SYSTEM is 1.001
(525).
Adjusts the horizontal lock phase in relation to the
reference signal (steps).
Adjusts the horizontal lock phase in relation to the
reference signal (fine adjustment).
Adjusts the vertical lock phase in relation to the
reference signal (line).
Sets the output signal of the LOOP/SYNC OUT
connector.
This is enabled only when MAINTENANCE Menu t
<I/F SETTINGS> page t LOOP/SYNC is SYNC.
17