Drive System; Pickup Motor; Feed Motor - Canon DADF-M1 Service Manual

3.3 Drive System

3.3.1 Pickup Motor

3.3.1.1
Removing the
Rear Cover
Refer to Procedure 3.2.2
3.3.1.2
Removing the

Pickup Motor

1) Disconnect the connector [1], and
remove the 2 screws [2]; then, detach the
pickup motor [3].
[1]
[3]
F-3-10
When mounting it, be sure that the
timing belt is properly attached to the
pulley.
0003-7141
0003-3079
[2]
[1]

3.3.2 Feed Motor

3.3.2.1 Removing the
Rear Cover
Refer to Procedure 3.2.2
3.3.2.2 Removing the
Harness Guide (right
rear)
1) Remove the screw [1], and disconnect
the 4 connectors [2]; then, free the harness
form the harness guide [3].
F-3-11
3.3.2.3
Removing the
Cooling Fan
Refer to Procedure 3.5.1.2
Chapter 3
0003-7139
0004-0816
[1] [2]
[3]
0003-7156
3-5