[1]
[4]
F-3-70
4) Move the original width volume [4]
toward the front or the rear to make
adjustments.
5) Tighten the screw [1] you have loosened
and the screw you have fitted in the
adjusting angular hole [3].
6) When done, attach the cover [2].
7) Make copies of the Test Chart once
again, and check to see that the images are
as indicated.
3.5.3 Pressurization Solenoid
3.5.3.1
Removing the
Front Cover
Refer to Procedure 3.2.1
3.5.3.2
Removing the
Locking Solenoid
1) Remove the 2 screws [1] and the spring
[2]
[3]
0003-8107
0003-8037
[2]; then, detach the locking solenoid [3].
[1]
[2]
F-3-71
3.5.4 ADF Driver PCB
3.5.4.1
Removing the
Rear Cover
Refer to Procedure 3.2.2
3.5.4.2
Removing the
ADF Driver PCB
1) Remove the 3 screws [1], and
disconnect the 7 connectors [2]; then,
detach the harness guide [3].
Chapter 3
[3]
0003-8100
0004-0744
3-29