Feed Drive System; 1Overview; Overview; 2Constraction Of The Control System - Canon Puncher Unit-P1 Service Manual

Chapter 2

2.2 Feed Drive System

2.2.1 Overview

The puncher unit is located on the feed path between the host machine and the finisher, and successively punches
holes when the paper stops temporarily.
The paper delivered from the host machine is fed by the punch feed roller. The punch feed roller is driven by the
punch feed motor. When the trailing edge of the paper reaches the puncher unit, the inlet roller of the finisher unit
temporarily stops the paper and holes are punched on the trailing edge of the paper.
The following shows the names and functions of the motors and sensors used in punching operation:
Motor
Punch motor (M61)
Horizontal registration motor (M62)
Punch feed motor(M63)
Sensor
Horizontal registration home
position sensor (PI61)
Punch motor clock sensor (PI62)
Punch home position sensor (PI63)
Horizontal registration sensor
(LED1 to LED4,PTR1 to PTR4)
Trailing edge sensor (LED5,PTR5)
Scrap full detector sensor
(LED6,PTR6)

2.2.2 Constraction of the Control System

The puncher unit consists of a die and hole puncher (punch blade).
The hole puncher is driven by the punch motor (M61). The hole puncher is attached to the
eccentric cam of the punch shaft, and rotary action of the punch shaft is converted to reciprocal motion to perform
punching.
Punch motor (M61) is a DC motor. The home position of the punch shaft is detected by punch home position sensor
2-2
T-2-1
Function
Drives the punch unit.
Drives the punch slide unit.
Drives the punch feed roller.
T-2-2
Function
Detects the punch slide unit home position.
Detects the punch motor clock.
Detects the punch shaft home position.
Detects the position of the rear edge of paper.
Detects the trailing edge of paper.
Detects the state of the punch waste case (full).
0003-9479
0003-4698