Leading Edge Registration - Canon DADF-M1 Service Manual

5) Tighten the screw [1] that has been tentatively tightened and the screw [3] that has been
fitted in the adjusting angular hole.
6) When done, mount back the cover.
7) Make a copy of the Test Chart once again, and see that the image is as indicated.

4.3.1.11 Leading Edge Registration

1) Obtain the Text Chart.
If the Text Chart is not available, make one using A4 or LTR paper as follows:
2) Place the Text Chart in the original tray, and make a copy of it at a 100% reproduction
ratio.
3) Check to see that dimension A of the Test Chart and the image obtained in step 2) are as
indicated:
A </= 1 mm
B </= 1 mm
If not, go to step 4).
10mm
Right angle
F-4-47
10mm
Chapter 4
0003-2362
4-39