4.3.1.2 Angle Guide (angle of opening at 90 deg)
Adjust the angle of opening. If it is 90 deg, go to the next item of adjustment (i.e. tray
width).
1) Bend over the edge of the rubber cover [1], and remove the 2 mounting screws [2]; then,
detach the angle guide plate [3].
[1]
F-4-32
4.3.1.3 Sensor Output
Make the following adjustments if you have replaced any of the following parts:
- reader controller PCB
- post-separation sensor (PI7)
- read sensor (PI8)
- delivery reversal sensor (PI9)
[3]
[2]
[1]
Chapter 4
0003-1796
0004-9325
4-25