Automatic Redialing - Sharp UX-CD600 Operation Manual

Redial
You can automatically redial the last number dialed on the fax machine.
Note: The fax machine and the cordless handset each retain their own
separate redial numbers.
1
Load the document(s).
•
If desired, press
resolution and/or contrast.
2
Press once. <REDIAL> appears in the display, followed by the last
number dialed. Make sure the number that appears is the number you
wish to dial.
START/MEMORY
3
Press
Note: If a fax transmission is unsuccessful and DOCUMENT JAMMED
appears in the display, remove the document as explained on page 137. (This
may occur if the other fax machine doesn't respond properly when you
attempt to send the document.)

Automatic redialing

If you use automatic dialing (including Direct Keypad Dialing) to send a fax
and the line is busy, the fax machine will automatically redial the number. The
fax machine will make three redial attempts at intervals of five minutes. During
this time, RECALLING will appear in the display, followed by a two-digit
number assigned to the fax job. You will not be able to dial any other locations
while the message appears.
RESOLUTION/
RECEPTION MODE
to set the
. Dialing begins.
Sending a Fax by Automatic Dialing
93