Sharp UX-CD600 Operation Manual page 134

Messages and Signals
FAX RX IN MEMORY
FUNCTION MODE
HSn IN USE
(where "n" is a number
from 1 to 8)
INTERCOM
L1/L2: HSn IN USE
(where "n" is a number
from 1 to 8)
LINE BUSY
LINE ERROR
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
132
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The FUNCTION key has been pressed.
The cordless handset indicated by "n" is currently
accessing the machine (using the Common book for
auto dialing, listening to messages, etc). Wait until
this message no longer appears to use the machine.
A cordless handset is paging the machine (lift the
handset to talk), or the machine is paging a cordless
handset. The name and number of the cordless
handset also appear.
The cordless handset indicated by "n" is currently
using the indicated line. "AVAILABLE" will appear
next to the other line if the other line is free.
The line you selected is in use, or both lines are in
use. Select a different line or wait until a line is free.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page
124.
The memory is full. You may have too many
messages recorded in the answering system. To
erase messages, see page 67.
This message may also occur during fax reception if
too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional
message will indicate the problem), resolve the
problem so that printing can continue (see Substitute
Reception to Memory on page 104).
If you are attempting to transmit from memory, see If
the memory becomes full on page 97.
If you are copying, see If MEMORY IS FULL appears
on page 106.