Setting A Passcode For A Personal Box - Sharp UX-CD600 Operation Manual

3
Press once.
4 START/MEMORY
Press
record the message.
•
While recording, the display will show the time left to record.
5
When finished, press
To delete or check an outgoing message
To delete or check an outgoing message, follow Steps 1 through 3 of the
above procedure to select the message, and then press
PLAY/
to check. Note that the general outgoing message cannot be deleted.
HOLD
If you need to change it, simply repeat the recording procedure.
Note: If a passcode has been set for a personal box as explained below,
deleting the OGM of the personal box will also clear its passcode.

Setting a Passcode for a Personal Box

You can set a 3-digit passcode for each personal box. When this is done, the
passcode must be entered to listen to messages in a personal box at the
machine. (Note: When listening to the messages in a personal box from its
corresponding cordless handset, it is not necessary to enter the passcode. )
♦
An outgoing message must be recorded for a personal box before a
passcode can be set.
1
FUNCTION
Press
2
Press once and
and speak facing "MIC" on the operation panel to
STOP
.
once and once.
once.
Setting a Passcode for a Personal Box
FEB-20 10:30
START: RECORD
Display:
T.A.D. SETTING
BOX PASSCODE
to delete or
DELETE
63