Sharp UX-CD600 Operation Manual page 26

Setting Up
♦
To clear a mistake, press
♦
To enter a lower case letter, continue pressing the key for the letter until the
lower case letter appears.
♦
To enter one of the following symbols, press
. / ! " # $ % & ' ( ) + + , - : ; < = > ? @ [ ¥ ] ^ _ ' { | }
7 START/MEMORY
Press
STOP
8
Press
♦
In the event that you need to change the name, clear it (press "2" in Step 4
on the previous page and then follow Steps 5, 7, and 8), and then repeat
the name entry procedure to enter the new name.
♦
If you purchase an additional cordless handset and enter it's name after
registering it in the machine, the name is also transmitted to all other
cordless handsets that you have for the machine. For this reason, make
sure that all cordless handsets are within the talking range of the machine,
their batteries are sufficiently charged, and that none are in use before
entering the name of the new cordless handset. To check whether the
name of the new cordless handset was successfully transmitted to the
other cordless handsets, press
followed by
appears in the display. The name will appear next to the number if it was
transmitted successfully. If the name does not appear, repeat the name
entry procedure.
24
SPEAKER
to store the name.
The handset number
to exit. and name appear in
the standby display of
the cordless handset
or until the number of the new cordless handset
.
or
INTER
on each of the other cordless handsets
COM
repeatedly:
) (
Display:
OWN NUMBER SET
HANDSET1
BILL