Dialing And Transmission Problems - Sharp UX-CD600 Operation Manual

Dialing and transmission problems

Problem
No dial tone when you
pick up the handset or
press the SPEAKER key.
Dialing is not possible.
The power is on, but no
transmission takes place.
Nothing is printed at the
receiving end.
A distorted image is
received at the other end.
• Make sure the handset cord is connected to the
correct jack. See Connecting the handset on page
16.
• Make sure the power cord is properly plugged into
a power outlet.
• Make sure that the telephone line is properly
connected to correct jack on the machine and the
wall jack (see page 17).
• Make sure that the machine is set to the correct
dialing mode for your telephone line. See page 35.
• Make sure that the receiving machine has paper.
• If the receiving machine is in manual mode with no
attendant, reception will not be possible.
• Check the display for error messages.
• Pick up the handset and check for a dial tone.
• Make sure that the document for transmission is
placed face down in the feeder.
• Noise on the telephone line may cause distortion.
Try sending the document again.
• Make a copy of the document on your machine. If
the copy is also distorted, your machine may need
service.
Problems and Solutions
Solution
125