Transaction Report - Sharp UX-CD600 Operation Manual

Transaction Report

This report is printed out automatically after an operation is completed to
allow you to check the result. The machine is set at the factory to print out the
report only when an error occurs.
♦
The Transaction report cannot be printed on demand.
Headings in Transaction Report
SENDER/
RECEIVER
START
TX/RX TIME
PAGES
NOTE
The name or fax number of the other machine involved in the
transaction. If that machine does not have an ID function, the
communication mode will appear (for example, "G3").
The time at which transmission/reception started.
Total time taken for transmission/reception.
Number of pages transmitted/received.
(One of the following notes will appear under NOTE in the
report to indicate whether the transaction was successful,
and if not, the reason for the failure.)
OK - Transmission/reception was successful.
P.FAIL - A power failure prevented the transaction.
JAM - The printing paper or document jammed, preventing
the transaction.
BUSY - The fax was not sent because the line was busy.
COM.E-X - (Where "X" is a number.) A telephone line error
prevented the transaction. See Line error on page 124.
CANCEL - The transaction was cancelled because the
STOP key was pressed, no document was in the feeder, or
the other machine requested transmission using a function
which your machine does not have. If you were attempting to
fax, make sure a document is in the feeder. If you were
receiving, contact the faxing party to see how they are trying
to send to you.
Printing Lists
117