Table of Contents
Advertisement
C t P R o F o R M a n C E ™ s t a R t - u P P R o C E d u R E s
•
Turn on exhaust hood.
•
Turn on water supply.
•
Turn on gas supply valve (if applicable).
•
Turn on main electrical power to appliance.
•
Press Power ON icon on the
appliance control panel.
The oven will automatically fi ll the steam generator
equipped models with water that will heat to a stand-by
mode temperature of 188°F (77°C).
NOTICE: To power off the appliance, press and hold
the power icon for 5 seconds to initiate power shut
down sequence to the oven. Oven will not shut down
during a cooking cycle. From time to time, the control
may become unresponsive. ONLY when this happens,
fi rmly press and hold the power key for 10 seconds to
power down the oven.
If, for any reason, the oven is turned off or loses power
during this start-up process, the operator will be
prompted to calibrate the Touch screen when the oven is
next powered up.
Return to Home Screen - Press the red arrow if
the PROtouch™ screen does not need to be calibrated.
Begin Calibration Process - Press the green
check mark if the Touch screen does need to be
calibrated. The screen will switch to a grey background.
See illustration at right. A crosshairs icon will appear.
The operator should touch the center intersection using
a stylus for an accurate calibration. This prompt and
required action will be repeated several times in different
areas of the Touch screen. When complete, the operator
will be returned to the Home screen.
NOTICE: Accumulations on the main burners
can result in fi ring out of normal
sequence. This delayed ignition creates
an alarmingly loud sound. If your
appliance makes an especially loud
noise when starting up, shut down
your appliance and call a qualifi ed and
trained service technician.
In the event of a power failure, the
oven will not operate.
COMBITHERM CT PROFORMANCE AND CT CLASSIC SERIES • INSTALLATION MANUAL • MN-35947 • 57.
Ct PRoFoRManCE™ staRt-uP PRoCEduREs
When the oven is powered
on, the PROtouch screen
illuminates. "Loading"
indicates that the software is
booting up. The screen will also
indicate what level of progress
has been made as the software
becomes fully operational. See
illustration at left.
d a n G E R
Before starting the appliance, make
certain you do not detect the odor
of gas.
IF YOU SMELL GAS:
• Shut off the gas supply immediately.
• Do not attempt to light any appliance.
• Do not touch any electrical elements.
• Extinguish any open fl ame.
• Evacuate the area.
• Use a telephone outside the property
and immediately contact your gas
supplier.
• If unable to contact your gas supplier,
contact the fi re department.
Advertisement
Table of Contents
