Table of Contents
Advertisement
G R E a s E C o l l E C t i o n i n s t a l l a t i o n (
Thumb screw
Hose guide
bracket
A
Grease Collection Hose
•
Grease Collection Hose Assembly is attached to
the oven in the back.
•
The hose guide bracket can be attached on
either the left side or the right side toward the
back. Placement on the left side is recommended
whenever possible. Thumb screws are in position
for this purpose. Remove thumb screws, position
hose guide bracket and secure screws (
Thread grease hose through the guide.
•
The hose hanger bracket can be attached on
either the left side or the right side toward the
front of the oven. Placement on the left side
is recommended whenever possible. Remove
the plastic protective film from the bracket
(
,
). Pan head screws are in position
PHOTO B
C
beneath the oven for this purpose. For stacked
configurations, always place the hanger bracket
on bottom of the top oven. Remove pan head
screws and washers (
hanger bracket on either side of the oven and
secure screws and washers (
bracket is used to secure the grease collection
hose while changing grease collection containers.
•
Place Grease Collection Containers inside the tray
of the Mobile Grease Collection Cart. Roll into
place next to the oven and apply the caster brake.
•
❖
Loosen vent cap on container. Pull out the
Grease Collection Hose Assembly from the back
of the unit. Remove collection container fill cap
(
).
PHOTO G
•
Screw Grease Collection Hose Assembly on to
collection container until snug.
•
Turn ball valve handle to the ON position.
COMBITHERM CT PROFORMANCE AND CT CLASSIC SERIES • INSTALLATION MANUAL • MN-35947 • 55.
i n s t a l l a t i o n
Hose hanger bracket with fi lm
B
D
).
PHOTO A
), position hose
PHOTO D
,
). The hanger
PHOTO E
F
i F e Q u i P P e d W i t H t H i S o P t i o n
Hose hanger bracket
C
E
Grease
Vent
Collection
Cap
Container
F
On/Off Ball Valve
G
Recommended
Container
Capacity
Fill Cap
)
Advertisement
Table of Contents
