Table of Contents
Advertisement
S I T E I N S T A L L A T I O N
w A R N I N g
To prevent SERIOUS INJURY, DEATH, or
PROPERTY DAMAGE:
• ALWAYS keep appliance on top of a pallet
when using a fork lift or a pallet lift truck
to move appliance.
• ALWAYS use a suffi cient number of trained
and experienced workers to place the oven
on fl oor, stand, or counter.
INSTALLATION
To insure proper operation, the installation of this oven
must be completed by qualified technicians in accordance
with the instructions provided in this manual. Failure to
follow the instructions provided may result in damage to
the oven, building, or cause personal injury to personnel.
NO TICE :
To prevent PROPERTY DAMAGE:
Check the dimensions of the
doorways and aisles before
attempting to move the oven and
pallet to the installation site.
Do not tilt the oven. Transport
the oven in an upright and level
position only.
Slide the preheat strip into place
before using a forklift or pallet jack
in between the trolley guides to
avoid damaging the preheat strip
when lifting.
LIFTINg INSTRuCTIONS
Remove banding before lifting. Lift the unit
from the front only, never from the side.
Adjust the forks so that they do not damage any
of the components under the unit. Note that the
control side of the oven is the heaviest portion.
Lift the unit just high enough to remove the
wooden pallet. Lower the unit as close to the
floor as possible and no more than 2" (50mm)
above the floor. Secure hoses and dangling cords
to avoid tangling or damage. when moving
the unit, drive slowly, keep it low to the
ground, and use extreme caution.
COMBITHERM CT PROFORMANCE AND CT CLASSIC SERIES • INSTALLATION MANUAL • MN-35947 • 34.
INSTALLATION
grease Collection pump
components
protrude below
oven
depth of forks is critical for units
equipped with grease collection to avoid
damaging the pump
®
Advertisement
Table of Contents
