Advertisement
Quick Start Guide
1.0
Optional: Power/device check
The device is designed to be installation-ready. To check device battery prior
to installation, perform the following:
1. Perform
2. Slide the ON/OFF switch to the OFF position until ready for use.
2.0
Optional: Normal range indication option
Note
The stickers are intended to be installed on the dial only and should not be applied on
the inside or outside of the housing cover.
Stickers should be applied in an environment where the ambient temperature is above
50 °F (10 °C).
1. Modify each of the stickers to desired size.
2. Remove housing cover.
3. Slide ON/OFF switch to the OFF position and wait for LED to stop flashing.
4. Gently move the needle in the clockwise direction until it is pointing at the
Red X.
Note
Use caution as the electronics assembly is connected to the needle.
5. Remove any debris on the dial, so it does not become trapped under the
sticker.
6. Peel back the white paper backing of the sticker.
7. Slowly lower the sticker onto the surface of the dial in the desired location
and rub it in place firmly. Repeat steps
locations are set.
Note
Moving the sticker after initial contact is not recommended as this decreases the
amount of adhesive on the back of the sticker.
8. Slide ON/OFF switch to the ON position.
9. Replace housing cover.
4
"Turn on device" on page
6.
6
and
7
until desired indication
February 2018
Advertisement
