Activesync Connection Via Ethernet - Casio IT-600 Series Quick Start Manual

5.8 ActiveSync Connection via Ethernet

This operation works with ActiveSync Version 3.8 or earlier. Later versions of ActiveSync do not
support the LAN ActiveSync setting menu and thus it is not possible to connect the IT-600 to PC via
WLAN or wired LAN.
With ActiveSync version 3.8 or earlier version, another way to establish wireless connection for
models without the WLAN module integrated (IT-600M30, M30C, M30E2, M30C2, M30E2-CN,
M30C2-CN) is to use the HA-D62IO Ethernet cradle that makes a high speed LAN access possible.
Follow the steps below to establish connection between the IT-600 and PC via the Ethernet cradle.
1. Establish partnership first between the IT-600 and PC using any method so far described in this
guide (connection establishment via either IrDA, USB cradle or Ethernet cradle).
2. Connect the dedicated AC adapter to the Ethernet cradle as described in Chapter 4.2.
3. Connect one end of the network cable to the Ethernet cradle and the other end to the network hub.
4. Make sure the selector switch on the back of the HA-D62IO Ethernet cradle is set to the position
"LAN". See Figure 5.31 below.
Figure 5.31
5. Navigate to Start → Setting → Control Panel → Network and Dial-up Connections.
Figure 5.32
Set to LAN
49