Casio IT-600 Series Quick Start Manual page 27

3. Set the selector switch on the back of the Ethernet cradle to the port that will be used. Set the
switch to "LAN" to use the LAN port or to "USB" to use the USB port.
Figure 4.5
4. Before using the cradle ports, remove the caps from the ports. When using a LAN, connect one
end of the LAN cable to the LAN port and the other end to the PC or hub. When using a USB
connection, connect one end of the USB cable (DT-380USB) to the USB port and the other end
to the computer.
Figure 4.6
5. Align the contacts on the underside of the IT-600 with the power supply contacts on the Ethernet
cradle and then set the IT-600 into the cradle so that mount holes in the back of the IT-600 are
aligned with the mount hooks on the cradle. Once the IT-600 is properly set in the cradle, the
power LED on the front of the Ethernet cradle lights green.
Figure 4.7
27