Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet DJ 4BAR LT BT User Manual

IRC-6 Infrared Remote Control

The 4BAR LT BT is compatible with the IRC-6 infrared remote control from Chauvet. To set the 4BAR LT
BT to IR mode, follow the instructions below:
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select ir.
4. Press <ENTER>.
5. Press <UP> or <DOWN> to select on or oFF.
6. Press <ENTER>.

IRC-6 Operation

Automatic Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
BLACK
AUTO SOUND
OUT
SENSI-
STROBE SPEED
TIVITY
To select a fading program:
%
MANUAL
FADE
R G B
To adjust the speed of the automatic program:
A UV W
-
+
0
Sound-Active Mode
1 2 3
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
4 5 6
7 8 9
Manual Color Control
To choose a specific color with the IRC-6:
To manually control the RGB percentage:
To activate or deactivate strobing:
Blackout
To black out the lights:
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
remote does not respond when a button is pressed, try pressing <BLACK OUT>.
You may have inadvertently activated Black Out.
Page 10 of 16
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to choose between the different auto programs, or press
<AUTO> to cycle through them.
1. Press <FADE> on the IRC-6.
2. Press <FADE> to cycle programs 5–8.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed of the program.
1. Press <SOUND> on the IRC-6.
2. Press <+> or <–> to choose between the different sound-active programs,
or press <SOUND> to cycle through them.
1. Press any number between <0>~<9> to choose a preset color.
1. Press <R> (red), <G> (green), or <B> (blue) to choose your color.
2. Press <+> or <–> to increase or decrease the value of each color.
• Pressing <R>, <G>, or <B> more than once will toggle that color between
255 and 0.
• Pressing <UV/P> more than once will toggle red and blue between 255 and
0. Green will stay at 0.
• Pressing <W> more than once will toggle red, green, and blue between 255
and 0.
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
1. Press <BLACK OUT> on the IRC-6.
Operation
4BAR LT BT User Manual Rev. 1