Master/Slave Mode (Wired); Master/Slave Mode (D-Fi Usb) - Chauvet DJ 4BAR LT BT User Manual

Master/Slave Mode (Wired)

The Master/Slave mode allows a single 4BAR LT BT product (the "master") to control the actions of one or
more 4BAR LT BT products (the "slaves") without the need of a DMX controller. The master product will be
set to operate in Stand-Alone or with the IRC-6, while the slave products will be set to operate in Slave
mode. Once set and connected, the slave products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 3Ch shows on the display.
2. Press <ENTER>.
3. Set the DMX address to d 1.
4. Connect the DMX input of the first slave product to the DMX output of the master product.
5. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
6. Finish setting and connecting all the slave products.
Master product:
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select out.
4. Press <ENTER>.
5. Press <UP> or <DOWN> to select dMX (to Master/Slave with non-BT products) or SLAV (to
Master/Slave with other BT products).
6. Press <ENTER>.
7. Set the master product to operate in Stand-Alone or IR mode.
8. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave operation
because the controller may interfere with the signals from the master.
• Do not connect more than 31 slaves to the master.

Master/Slave Mode (D-Fi USB)

The D-Fi USB allows a single 4BAR LT BT product (the "master") to control the actions of one or more
4BAR LT BT products (the "slaves") without the need of a DMX controller or DMX cables. The master
(transmitter) product will be set to operate in Stand-Alone mode, while the slave (receiver) products will be
set to operate in Slave mode. Once set and connected, the slave products will operate in unison with the
master product.
Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 3Ch shows on the display.
2. Press <ENTER> to accept.
3. Set the DMX address to d 1.
4. Set the D-Fi USB to receive on a specific channel, 1–16.
5. Plug in the D-Fi USB.
6. Finish setting and connecting all the slave products.
Master product:
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select out.
4. Press <ENTER>.
5. Press <UP> or <DOWN> to select dMX (to Master/Slave with non-BT products) or SLAV (to
Master/Slave with other BT products).
1. Press <ENTER>.
2. Set the master product to operate in Stand-Alone mode.
3. Set the D-Fi USB to transmit on the D-Fi channel the slaves are receiving on.
4. Plug in the D-Fi USB.
• All products must be set to the same DMX personality, DMX address, and D-Fi channel.
• Configure all the slave products before configuring the master to transmit.
• Never connect a DMX controller to a D-Fi channel configured for Master/Slave operation
because the controller may interfere with the signals from the master.
Page 12 of 16
Operation
4BAR LT BT User Manual Rev. 1