Charging The Pump - CME VET-PRO VIP 2000 Operator's Manual

Charging the Pump


NOTE:
The pump is protected against overcharging. In order to keep your battery fully
charged, connect the pump to the mains via the Charger whenever possible. Be sure that the
battery is fully charged at all times.
Warning:
charger connected to mains, the pump will turn off.
1. Connect the charger unit to AC power and verify that the AC indicator is lit.
2. Put the pump into the charger (top first) until it clicks into place.
3. The battery is charging when the red battery LED on the front of the charger is lit. The battery is
fully charged when the battery LED symbol turns green. If the LED does not light or does not turn
green after more than 8 hours, pls. replace battery.
4. Remove the pump from the charger by pressing the release button (located next to the LED
indicators on the charger) and lift the pump out of the charger bottom first.
Caution:
battery.
VET-PRO VIP 2000™ Color Vision Operator Manual
If the battery is removed during operation while pump is not connected to a
Leaving the battery fully depleted for a long period of time may damage the
3 – Installation and Set Up
20