CME VET-PRO VIP 2000 Operator's Manual page 61

Rate Screen – Step 2
5.
Pump displays the rate for step 2. Repeat directions as for
step 1 and repeat until the required number of steps have
been entered.
6.
After entering the last required step, press
entering a rate.
This indicates that all data required for the protocol has
been set. All programs following the last set program will be
automatically cleared.

NOTE:
If pump is in Delay Mode, enter KVO rate.
7. Accumulation Screen
Do one of the following:
 Press
to confirm the existing parameters.
 Press
to go back to rate setting screen.

NOTE:
If pump is in Delay Mode, enter Start Time (24 Hour Clock) and Start Date. For further
information regarding the Delay Option, refer to Delay Program section.
8.
Press to Start Infusion.
9. During program operation, the display identifies which step is currently running, and the rate.

NOTE:
If one of the values is changed during the programming mode, the pump will not recall
the new value unless changes are confirmed by pressing
If prime procedure is activated during data setting, the pump will return to the original (previous)
screen once priming is completed.

NOTE:
Whenever required to stop infusion, press
mode is limited for two minutes. After two minutes an audible alarm is sounded. Press
again to mute the alarm.
VET-PRO VIP 2000™ Color Vision Operator Manual
25 - Steps
Rate
Step 2
35
mL/hr
Adjust and press
25 - Steps
without
Rate
Step 20
x
mL/hr
Adjust and press
25 - Steps
Total Steps
Total Volume
Total Time
Air Sensor
Pressure
Press
25 - Steps
Start Infusion ?
Press
.
. Stop displays on the screen. Stop
4 – Operation
80% ███■
10:00 -
Key
80% ███■
10:00 -
Key
80% ███■
10:00 -
6
50.7 mL
0:24Hours
0.3 mL
730 mmHg
Key to Continue
80% ███■
10:00 -
key to Start
61