Commit, Discard, And View Pending Commands - Cisco Firepower 4100 Command Reference Manual

Commit, Discard, and View Pending Commands

Commit, Discard, and View Pending Commands
When you enter a configuration command in the CLI, the command is not applied until you enter the
commit-buffer command. Until committed, a configuration command is pending and can be discarded by
entering a discard-buffer command.
You can accumulate pending changes in multiple command modes and apply them together with a single
commit-buffer command. You can view the pending commands by entering the show configuration pending
command in any command mode.
Note All pending commands are checked for validity. However, if any queued command fails during commit, the
remaining commands are applied; failed commands are reported in an error message.
While any commands are pending, an asterisk (*) appears before the command prompt. The asterisk disappears
when you enter the commit-buffer command.
The following example shows how the prompts change during the command entry process:
Firepower# scope system
Firepower /system # scope services
Firepower /system/services # create ntp-server 192.168.200.101
Firepower /system/services* # show configuration pending
scope services
+
exit
Firepower /system/services* # commit-buffer
Firepower /system/services #
Cisco Firepower 4100/9300 FXOS Command Reference
10
create ntp-server 192.168.200.101
CLI Overview