Install Platform - Cisco Firepower 4100 Command Reference Manual

A R Commands

install platform

To upgrade firmware and software on the security platform components, use the install platform command.
install platform platform-vers version_number
Syntax Description
platform-vers
version_number
Auto install (/firmware/auto-install) mode
Command Modes
Command History
Release
1.4(1)
You must have administrator privileges to use this command. The upgrade process typically takes between
Usage Guidelines
20 and 30 minutes.
Before initiating installation, review the current critical/major faults and back up the current configuration.
You can use the show fsm status expand command in auto-install mode to monitor the installation process.
To complete the upgrade installation process, you must acknowledge the pending reboot of the primary
fabric-interconnect.
Example
This example shows how to install a platform upgrade package:
FP9300-A# scope firmware
FP9300-A /firmware # scope auto-install
FP9300-A /firmware/auto-install # install platform platform-vers 2.3(1.51)
The currently installed FXOS platform software package is 2.2(2.19)
INFO: There is no service impact to install this FXOS platform software 2.3(1.51)
This operation upgrades firmware and software on Security Platform Components
Here is the checklist of things that are recommended before starting Auto-Install
(1) Review current critical/major faults
(2) Initiate a configuration backup
Do you want to proceed? (yes/no):
Related Commands
Command
download image
show validate-task
Specifies the version of the platform package to install.
Modification
Command added.
Description
Downloads an FXOS software image to the Firepower 4100/9300 chassis.
Displays the status of the image verification process.
Cisco Firepower 4100/9300 FXOS Command Reference
install platform
105