Set Cluster-Control-Link Network - Cisco Firepower 4100 Command Reference Manual

set cluster-control-link network

set cluster-control-link network
To set the cluster control link IP network in the cluster bootstrap configuration for the FTD and ASA, use the
set cluster-control-link network command.
set cluster-control-link network a.b.0.0
Syntax Description
a.b.0.0
The default network is 127.2.0.0.
Command Default
scope ssa/create logical-device/create cluster-bootstrap/
Command Modes
Command History
Release
2.4(1)
The chassis auto-generates the cluster control link interface IP address for each unit based on the chassis ID
Usage Guidelines
and slot ID: a.b.chassis_id.slot_id.
Bootstrap settings are meant for initial deployment only, or for disaster recovery. For normal operation, you
can change most values in the application CLI configuration.
Example
The following example shows how to set the mode to routed mode:
firepower# scope ssa
firepower /ssa # create logical-device FTD1 ftd 1 clustered
Firepower /ssa/logical-device* # create cluster-bootstrap
firepower /ssa/logical-device/cluster-bootstrap* # set cluster-control-link network 10.10.0.0
firepower /ssa/logical-device/cluster-bootstrap* #
Related Commands
Command
create logical-device
create cluster-bootstrap
Cisco Firepower 4100/9300 FXOS Command Reference
176
Specifies any /16 network address, except for loopback (127.0.0.0/8) and multicast
(224.0.0.0/4) addresses. If you set the value to 0.0.0.0, then the default network
is used: 127.2.0.0.
Modification
Command added.
Description
Creates the logical device.
Creates the cluster bootstrap configuration for the application.
S Commands