Using The Alarmnet 360 Website; Using The 7720P Programming Tool - Honeywell LTE-X series Installation And Setup Manual

Using the AlarmNet 360 Website

To program the communicator via the website (if you are already signed up for this service), go to:
Alarmnet360.com (https://services.alarmnet.com/AlarmNet360/AlarmNetDirectV)
If you are not signed up for this service, click on "Dealer Sign-Up" and follow the instructions. Log in and follow the on-
screen prompts. Please have the following information available when programming the communicator:
•
Primary City ID (two-digit number), obtained from your monitoring station.
•
Primary Central Station ID (two-digit number), obtained from your monitoring station.
•
Primary Subscriber ID (four-digit number), obtained from your monitoring station.
•
Communicator's MAC ID and MAC CRC number (located on the box and inside the communicator).
After programming is complete, the communicator must be registered. Refer to the Register the Module topic.

Using the 7720P Programming Tool

Ensure the communicator is powered, and connect the
7720P Programming Tool.
Each key has two possible functions; a Normal function and
a Shift function.
•
To perform a Normal key function, simply press
the desired key.
•
To perform a Shift function, press the [shift] key,
then press the appropriate key.
The following table lists each normal and shift key function.
KEY NORMAL KEY FUNCTION
BS/ESC [BS]: Press to delete entry
↓/↑
[↓]: Scroll down programming
N/Y [N]: Press for "NO" answer
SHIFT Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes
out once a key is pressed. Press again for each SHIFT function desired.
1/A [1]: For entering the number 1
2/B [2]: For entering the number 2
3/C [3]: For entering the number 3
4/D [4]: For entering the number 4
5/E [5]: For entering the number 5
6/F [6]: For entering the number 6
7/S [7]: For entering the number 7
8/T [8]: For entering the number 8
9/X [9]: For entering the number 9
SPACE [SPACE]: For scrolling option list
0 [0]: For entering the number 0
#/ENTER [#/ENTER]: Starts programming
mode; Press to accept entries
* Active only when the "Exit Programming Mode" prompt is displayed.
LTE-X Series Installation and Setup Guide
7720P Normal and Shift Key (shift LED lit) Functions
SHIFT + KEY FUNCTION
[ESC]: Press to quit program mode; also
can reset programming defaults.
[↑]: Scroll up programming
[Y]: Press for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
[C]: For entering letter C
[D]: For entering letter D
[E]: For entering letter E
[F]: For entering letter F
[S]: For entering letter S
[T]: For entering letter T
[X]: For entering letter X
No SHIFT function
No SHIFT function
No SHIFT function
– 6 –
*