Printing Position In Relation To Cutter Position (Tm-L90) - Epson TM-L90 Technical Reference Manual

Printing Position in Relation to Cutter Position (TM-L90)

The TM-L90 printing position and cutter positions are shown in the following figure.
Note:
The values in the figure are central values. Slackness and differences in paper type can result in differences
developing between central values and cutter paper cut position. It is important to allow for a certain
margin of error when setting cutter paper cut position.
When operating using the ESC/POS commands, some paper-related commands allow you to feed paper
backward after an autocut.
•Back feed maximum amount
Receipt (without black mark):
Receipt (with black mark):
Die cut label (without black mark):
Die cut label (with black mark):
Label (no die cut) (without black mark): Approximately 11.5 mm (back feed amount is fixed)
Do not perform partial cutting and (one point left uncut) reverse feed together.
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Printing Position in Relation to Cutter Position
Approximately 11.5 mm (back feed amount is fixed)
Approximately 10.5 mm
Approximately 10.5 mm
Approximately 10.5 mm
29
14
Appendix 141