Clearing Paper Layout Setting - Epson TM-L90 Technical Reference Manual

• Directly control the printer using ESC/POS commands.
(Manual: ESC/POS Command Reference
For details on how to obtain this manual, see "Introduction of Control Methods" on
page 85).
Note:
For the Memory Switch Setting Utility and ESC/POS commands, refer to "Introduction of
Control Methods" on page 85.
When using the Advanced Printer Driver (APD) or ESC/POS commands, set the print area as
required. The print area position influences the paper layout. When using label paper with black mark,
always make a manual setting of paper layout.

2.9.4 Clearing Paper Layout Setting

This printer has a function to reset the paper layout set in the automatic paper layout setting
mode or by manual setting to the factory setting.
Note:
This function may be unavailable depending on when you purchased your printer. You cannot use this
function if the firmware version of the printer printed in a self test ("Memory Switch Settings" on
page 44) is 1.04 or earlier. For more information, please contact your sales representative.
The method of clearing the paper layout settings in the printer is as follows.
1. Open the peeler cover.
2. Open the roll paper cover.
3. Load roll paper.
4. Until the ERROR LED is on, hold down the FEED button (on the inside of the roll paper
cover: see page 44) and turn on the power supply.
5. When the ERROR LED comes on, release the FEED button (inside the roll paper cover).
6. Press the FEED button 4 times.
7. Close the roll paper cover.
The paper information in the NV memory in the printer is cleared, and to indicate that
the layout information is cleared, the printer automatically feeds paper.
64 Setup