Chapter 4 Setting/Checking Modes; Setting/Checking Modes Of Tm-L90 4** Models, Tm-L90 Peeler 39* Models - Epson TM-L90 Technical Reference Manual

Chapter 4
Setting/Checking Modes
4.1 Setting/Checking Modes of TM-L90 4** models, TM-L90 Peeler 39*
models
Besides the ordinary print mode, the printer has the following modes to set or check settings of
the printer.
❏ Self-test Mode
❏ NV Graphics Information Print Mode (page 79)
❏ Memory Switch Setting Mode (page 80)
❏ Hexadecimal Dump Mode (page 81)
The self-test mode or hexadecimal dumping mode is selected depending on the operation
performed when the power is turned on.
NV graphic information print mode and the memory switch setting mode are selected
depending on the FEED button operation performed during a self-test.
Close the roll paper cover, and turn on the printer while pressing the FEED button.
Briefly press the FEED button.
Continuing the self-test
Press the FEED button once briefly and
NV Graphics Information Print
Open the roll paper cover, and turn on the printer while pressing the FEED
button, and then close the roll paper cover.
(For Peeler Models only) Load paper in the paper path, and then press the
FEED button.
then hold it down.
Hexadecimal Dumping
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Self-test
Hold down the FEED button.
Mode selection guide
Press the FEED button twice briefly and
then hold it down.
Memory Switch Setting
Setting/Checking Modes 77