Setting Items Of Tm-L90 Peeler 39* Models - Epson TM-L90 Technical Reference Manual

8: Other settings
11: Select label

Setting items of TM-L90 Peeler 39* models

See "Memory Switch Settings" on page 44 for the procedures for the memory switch setting
mode.
1st page
1: Print Current Settings
2: Print Density
3: Serial
Interface
Settings
4: Paper Width
126 Appendix
Setting Items
2nd page 3rd page
1: 1: Density Sample
Monochrome
2: Density List
1: Baud Rate
2: Parity
3: Handshaking
4: Data Bits
5: Data Receive Error
[Selection of the PAPER OUT LED status when a paper
near-end is detected]
On, Off
[Recovery selection when paper layout error occurs]
DLE ENQ or cover open/close
DLE ENQ
[Select automatic measurement of maximum length for
paper]
160 mm, 300 mm
[Select moving to the print starting position when power is
turned on]
moves to starting position
does not move
* The initial setting is underlined.
-
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%,
120%, 125%, 130%, 135%, 140%
2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600
bps, 115200 bps
None, Odd, Even
DTR/DSR, XON/XOFF
7 bits, 8 bits
Print "?", Ignored
80 mm, 70 mm, 60 mm, 58 mm, 38 mm
Options