Chapter 7 Handling; Maintenance; Cleaning The Autocutter (Tm-L90 Only) - Epson TM-L90 Technical Reference Manual

Chapter 7
Handling

7.1 Maintenance

7.1.1 Cleaning the autocutter (TM-L90 only)

If label paper adhesive has stuck to the autocutter, it may dull the cutting edge. In such a case,
clean the cutter blade using the following procedure.
1. Turn off the power.
2. Disconnect the printer from the power connector.
3. Open the roll paper cover.
Note:
If the roll paper cover will not open, take action in accordance with the troubleshooting of the
autocutter (page 118).
4. As shown below, remove the adhesive residues accumulated on the cutter blade on the roll
paper cover side with a cutter knife or similar tool.
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Adhesive adheres on cutter blade
Handling 107