Paper Feed Specifications; Paper Specifications - Epson TM-L90 Technical Reference Manual

Paper Feed Specifications

Item
Paper feed method
Paper feed direction
Precautions for Printing and Paper Feed
❏ Being a line printer, this printer always feeds paper to print. Therefore, when the line
spacing of a single line is set to less than that of the print data, paper may be fed more than
the setting to print.
For example, when the line spacing of a single line is set to 10 dots, paper feed of 10 dots is
executed to only make a carriage return, but paper feed of 24 dots is executed to print a bit
image. (See the following table.)
Paper feed
Standard
character
Rotatable
character
Bit image
❏ When the printer is placed in the wait state for data from the host during printing, it
temporarily stops printing and paper feed. When data is entered and printing restarts, paper
feed may be disturbed between 1 to 3 dot lines at a print start. This especially affects the
printing of a bit image.
❏ It is recommended to start autocutter operation after printing or paper feed of 10 or more
lines. (This is because a small piece of cut paper is difficult to eject and may cause a paper
jam.)

Paper Specifications

Refer to "Consumable Specifications" on page 154.
138 Appendix
Specifications
Friction feed
Single-direction
Necessary paper feed (dots)
24 vertical magnification
Font A
17 vertical magnification
Font B
24 vertical magnification
Kanji font
12 vertical magnification
Font A
9 vertical magnification
Font B
24 vertical magnification
Kanji font
24 vertical magnification