Print Specifications - Epson TM-L90 Technical Reference Manual

Print Specifications

Item
Printing method
Dot density
Printing direction
Paper width
Maximum printable area
Characters per line
Print Speed
Carriage return width
Note:
The print speed listed above is the value when the printer prints with the default print density level at 24

V and 25 C. The print speed may be changed automatically with the condition of the supply voltage or the
head temperature.
Printing speed may be slower depending on the data transmission speed and the combination of control
commands.
TM-L90/TM-L90 Peeler Model Technical Reference Guide
Specifications
Thermal line printing
0.125 mm/dot x 0.125 mm/dot (203 dpi x 203 dpi)
(dpi: dots per 25.4 mm {1"})
Unidirectional with friction feed
80mm (79.5±0.5mm) (default setting)
It is possible to set optional positions in the range of 38 to 70 mm {1.50
to 2.76"}. The range of 71 to 79 mm {2.80 to 3.11"} cannot be set.
72 mm {2.83"}, 576 dot positions
(when the paper width is 80 mm)
Font
✕
Font A 12 24
✕
Font B 9 17
✕
Kanji 24 24
✕
Kanji 20 24
✕
Kanji 16 16
(Default setting is font A.)
<Normal printing> (default setting)
120 mm/s {4.72"} maximum
<High speed printing> (selected with the memory switch)
150 mm/s {5.91"} maximum
(The high speed printing can be selected when the specified paper
is used.)
<Ladder barcode, two-dimensional code printing>
90 mm/s {2.76"} maximum
<Multi-tone graphics printing*> (only supported with APD)
120 mm/s {3.54"} maximum (*: available only for 4** models)
3.75 mm {0.15"}
Programmable by control command.
Characters per line
(with 80 mm paper
width)
48
64
24
28
36
Appendix 133