Problems With Print Quality; Horizontal White Banding; Vertical White Spots (Auto Cutter Model); Printing Is Impossible Or Becomes Suddenly Impossible - Epson ColorWorks CW-C6000 Series User Manual

Problems with Print Quality

Horizontal White Banding

Cause
The nozzles are clogging.

Vertical White Spots (Auto Cutter Model)

Cause
The printed label has been back-
fed.

Printing is Impossible or Becomes Suddenly Impossible

Print Data is Sent, But Does Not Print (Peeler Model)

Cause
The detector is malfunctioning.
Print the nozzle check patterns to check the nozzles for clogging.
Nozzle Check Patterns" on page
If the nozzles are clogging, run a print head cleaning.
Head" on page 61)
If printed labels are fed backward, the printed surface is damaged by the
rollers located under the paper pressure unit.
This can occur when the print mode is set to "Stop at Cut Position" or "Stop at
Peel-Off Position", and printed labels have not been removed after each print
job is finished.
Select a print mode option other than "Stop at Cut Position" or "Stop at Peel-
Off Position", or remove printed labels after each print job is finished.
For details on the print modes, refer to the CW-C6000 Series/CW-C6500 Series
Technical Reference Guide.
If printing is performed at a location exposed to strong light such as direct sun
rays, etc., the detector may not work properly, making it impossible to perform
printing.
Press the Peeler Reset button to cancel the non-printing state.
Solution and Reference
26)
Solution and Reference
Solution and Reference
Troubleshooting
(U"Printing
(U"Cleaning the Print
68